BusIO PUSH BUTTON SWITCH BOARD

BusIO PUSH BUTTON SWITCH BOARD
Item# MR-BusIO-SW
$5.99, 10/$53.91, 50/$239.60

Product Description:

BusIO PUSH BUTTON SWITCH BOARD
MR-BusIO-SW is an experiment board for receiving input from push button switch. When the switch has been pressed, the indicator LED is illuminated and status on I/O pin is LOW. Moreover, user can add DS18S20 IC, 1-Wire Digital Thermometer onto the board. It can send the temperature value via 1-Wire bus system to microcontroller (optional). It is best for sensing switch input and temperature reading.

The board can be use with MR-BusIO-MAIN board or stand-alone. PCB size is 0.63” x 2.80”

There are three ways to use this board:

As a switch input: When user press the switch, logic LOW is apply at the I/O pin. The indicator LED is also illuminated. I/O pin read logic HIGH when the switch is de-press.

As a VR (Variable Resistor): This is optional. User has to solder 10 POT on to the board. It’s operating as a voltage divider of VCC.

As an 1-Wire Thermometer (DS18S20): This is optional. User has to solder 3-PIN DS18S20 on to the board, pin1 GND, pin2 DQ, and pin3 VCC. The 1-Wire data can be read from an I/O pin. Do not connect VR when using this option.

For more information please see: MR-BusIO-SW User Manual