Proto Shield Kit for Arduino Mega
Product Description:
The
Arduino Mega now has its very own prototyping shield! The MegaShield mates with the Arduino Mega board and gives the user a prototyping area, two general LEDs, and, most important of all, the Arduino Mega reset switch is brought to the top level. The shield also works with our
small breadboards if you don't want to solder to the prototyping area.
This comes in kit form and must be soldered together by the end user. All soldering is through-hole (relatively easy) but always check your component orientation before soldering!
Kit Includes:
•1x MegaShield PCB
•11x
8-pin Stackable Headers
•1x Bright 5mm Green LED
•1x Bright 5mm Red LED
•2x 330 Ohm resistors
•1x
Momentary Push Buttons
•1x 10k resistor
Features:
• All Arduino Mega pins are brought to the top level
• 5V and GND power busses
• Power and stat (connected to D13) LEDs
• Reset Button brought to top level
Documents:
•
Protoshield Schematic
•
Eagle Files
•
Assembly Tutorial by Bob Gallup
•
Arduino Home Page
